ICCP Powered Anode Rod System. Stops Internal Tank Corrosion & Hot Water Odor.

Solid State Electronic ICCP Powered Anode Rod System
Never Settle For Imitation Powered Anode Rod Systems!
How Our System Works
In Your Water Tank
ICCP
(impressed Current Cathodic Protection) is a term used for electronically
protecting metals which are subject to corrosion with a safe low voltage D/C
current. This system replaces the factory installed Aluminum Anode Rod (your
odor source) inside the Water Heater Tank with a non-degrading Titanium Anode
Sensor Rod. The Hot Water Odor will be gone within 1 tank cycle, corrosion
protection will start immediately. This system works in hot or cold water tank
systems from 10 to 110 gallons up to 212 degrees Gas or Electric.
All
connection points are bolt/nut style and made from Aircraft-Grade 303 stainless
steel. The Sensor Rod is made from 99.67% pure titanium. This product does not
incorporate any plastic parts which are prone to failure, epoxy glued
connection points, or slip-on wire connections as other products have. This
system is engineered for years of trouble free operation.
We
stand behind this product from the day you purchase it with a lifetime
replacement warranty. Should the Green/Red LED status light ever fails to stay
lit, contact us. Response time is within 24 hours or less and a new power
supply will be sent to you free of charge.
How Our ICCP System
Works
When
our system is plugged into any 110 volt outlet, the power supply will send a
current through the Sensor Rod to assess the water tanks electrical potential (tank size).
The power supply LED will be Red at this point. Within 3 seconds, the LED will
turn Green if the tank is within the 10 to 110 rated gallon capacity.
Our Sensor Rod
Our Titanium Sensor Rod is coated
with a MMO Ti (mixed metal oxide) which has been the industry standard for over
30 years in salt water environments. Little to no degradation is found to occur
for 15 or more years including high salt water environments.
The MMO Ti coating on this Sensor
Rod is there for an important reason. This added coating enables the complete transfer
of electrons from the Power Supply into the tanks Sensor Rod enabling complete electron
distribution.
Our Power Supply
Our
Power Supply is an engineered Solid State Circuit Design exclusively made for
ICCP Powered Anode Rod Systems and cannot be purchased on auction sites or any
retail outlet.
Our
system incorporates a
single Green/Red
LED status light. Should a ground wire or Sensor wire become loose over time,
the LED will turn
Red
to show the connection wire(s) need tightened. Once corrected,
the LED will automatically turn
Green
once
again
.
Our
system is a true ICCP system that other products only imitate. Our system will
add years to your Water Heater Tank well beyond the factory warranty by
stopping the internal corrosion. The benefits are your Hot Water Odor vanishing
and never having to change the Factory Anode Rod again.
Protects The Following
Water Heater Tank Size
Natural
Gas
, Electric, Geothermal and Propane.
Will work in
10 to 110 Gallons Tanks. If
you can find your Factory Anode Rod location, our product can be installed in
your system.
Installation
Socket
Size:
1-1/16 Inch Shallow 6 Point Socket
($8.00 at any hardware store). The factories uses Red 271 Loctite (permanent
epoxy) and it may be difficult to remove so get a helper. Do Not Drain the
water tank during installation. The added water weight will help stabilize the
tank when removing and installing our product. We include a short 2 page
installation procedure.
For water tanks that use Nipple Style Anode rods (bradford
white, see main photos), a plumbing adapter will be needed. Nipple style Anode
Rods are attached to your Hot Water inlet tube on top of your tank. The 4 parts
needed are available at any big box store at a Cost of $10.00 or Less. See our
main photo area for the parts needed.
Our system is the number #1 ICCP protection system designed for water tanks for a reason; honest product claims, the only solid state power supply controller on the market backed by a lifetime warranty.
Never Settle For Imitations!
Fast Free Shipping & Delivery
Times.
* All Units Shipped USPS. You Can
Expect 1/3 day Delivery  Times Nation Wide.
* Orders Received By
6:00
AM
Daylight Savings Time (DST) Will Ship Same Day Monday – Friday.
* Saturday Orders By
9:00 AM
Daylight Savings Time (DST) Will Ship The Same Day.
* Return Policy: 60 Days. All emails are answered within 24 ours or less.
* Warranty: Free lifetime replacement on the power supply should the LED fail.
* Ships from Muncie Indiana.